Set for carbines without a carving on a barrel

Description

Very often hunting carbines do not have a thread for the installation of muzzle devices, if there is a desire to install a MBC or suppressor, the solution is essentially one – to cut a thread on the barrel of the carbine.
Not many weapons workshops can do it well, so many shooters have doubts about the need for this procedure.

This kit avoids such operations with the barrel of the carbine!
It includes: MBC adapter + silencer, which is mounted on the MBC adapter. At the same time you get an effective muzzle brake compensator and suppressor!

Each MBC adapter is made individually, according to the sizes of a trunk of your carbine!

This design is tested on calibers up to 338LM.

From you measurements of the barrel of your carbine: the diameter of the barrel on the muzzle and 40 mm from the muzzle, below is a diagram of the removal of dimensions from the barrel of the carbine.

Each device is covered by a warranty: one year or 1000 shots.
The internal device of the suppressor is the original scheme developed by experts of our company.

PLEASE NOTE: the adapter must go into the barrel at least 40 mm. and lean into the slice of the barrel of the carbine.
The collet should be located strictly below (for six hours). Tighten the screws on the collet. After that on the MBC adapter it is possible to wind a suppressor.
All parts of the silencer made of D16T undergo a process of chemical treatment (anodizing), which significantly increases their service life.
Each silencer has its own original serial number and product passport.
REQUIRED FOR READING
RECOMMENDATIONS FOR CLEANING AND CARE
DELIVERY AND PAYMENT